Siemens 6DL1132-6BH00-0PH1 SIMATIC ET 200SP HA Digital Output Module

6DL1132-6BH00-0PH1 is a Siemens ET 200SP HA 16-channel source (PNP) output module for 24 V DC loads. Its 0.5 A-per-channel outputs can switch suitable solenoid valves, DC contactors and indicator lights within the documented current limits.

6DL1132-6BH00-0PH1 uses a SIMATIC ET 200SP HA terminal block of type H1 or M1. The terminal block is ordered separately; Siemens documents I/O redundancy with an M1 terminal block, so the installed station configuration must be checked.

6DL1132-6BH00-0PH1 provides 16 digital outputs rated 24 V DC and 0.5 A per channel. The module supply accepts 19.2–28.8 V DC; its total output current limit and temperature derating must be observed in the installed orientation.

6DL1132-6BH00-0PH1 supports configurable channel diagnostics, including wire-break and short-circuit detection, along with module supply monitoring. Configure the diagnostic parameters in the ET 200SP HA engineering project and investigate the corresponding channel or module indication.

6DL1132-6BH00-0PH1 has an output-disable switch for runtime removal. Siemens instructs pressing it for three seconds to de-energize the module before pulling it; the switch also interrupts any ongoing firmware update. Follow the system manual's replacement procedure.

6DL1132-6BH00-0PH1 measures 22.5 mm wide, 115 mm high and 138 mm deep, with an approximate 137 g module weight. The documented operating range reaches +70 °C horizontally and +60 °C vertically, subject to output-current derating.

6DL1132-6BH00-0PH1 should be identified by the complete Siemens article number, required quantity and installed ET 200SP HA station. Provide the H1 or M1 terminal-block type, load voltage/current and redundancy requirement so the output configuration can be checked.